When using existing Maxsurf reporting to Word some tables exceed page width. Typically to minimise this I do a search in Word and abbreviate/shorten certain terms. For example Freeboard becomes FB, positive becomes +ve, Embarkation becomes Emb, Ar...

Currently MOSES reports draft based on forward and aft points of the vessel during a stability check. When draft markers are defined to match the specific loading condition, certification agencies expect the draft to be reported based on the defin...

In many projects, client asks for a hydrostatic collapse check with increased water depth (eg: hydrostatic collapse check when water depth is increased by 33%). This scenario can arise during accidental damage of the system. Currently, this check ...

We define load cases for structural analysis lcase -process option. Currently, alphabetical order of these load cases is followed for reporting the outputs. For eg: in a launch analysis, if the load cases are defined as prelaunch, tipping, posttip...

In jacket models, there are requirements of having a connecting member which takes compression/tension only during certain operations. In SACS, such a member can be modelled using GAP element. Currently in MOSES, such a feature is not available. I...

Sometimes one is looking for a ballast configuration to achieve even keel, whereas the draft may vary. Thus, it would be nice to allow cmp_bal to alter certain degrees of freedom compared to the current system configuration (at least the draft).

Dear MOSES Team! What do you think about adding the possibility to include external dll's in MOSES analyses which are called every time step, e.g. to model active heave compensation systems, active roll damping devices, or power-take-off-systems m...

Dear MOSES team, Currently, hydrodynamic interaction between bodies is possible when the two "bodies" are modeled as a single body connected with weak structural elements. This is a bit inconvenient to model. How about adding something like outlin...

It will be good if MOSES Potvue provide an option under POST JOINT_CAN command to generate joint strength UC for all load cases instead of just maximum value. This option will be helpful to exclude joint strength UC requirement which has load UC &...

It's most useful that quick design starts with popular hull shapes, i suggest adding simple modifications to model like barge, to add bilge, knuckles, curved rakes, to make the modeling easier for simple barges. this will be very useful for offsho...