It will be good if MOSES Potvue provide an option under POST JOINT_CAN command to generate joint strength UC for all load cases instead of just maximum value. This option will be helpful to exclude joint strength UC requirement which has load UC &...

Add an option in the Model Settings tab to display the body coordinate system. Add an option in the Model Settings tab to display any suppressed DOF.

Want to add control points to a surface (which is the only one displayed on screen) but don't know which bonded surfaces might be affected? Please add a "Show Bonded surfaces" option together with the "show Intersecting Sufaces" and "Show Only Sel...

There is no visual way to check the correct postion and orientation of these connector type. When building a new model a lot of time is lost to check correctness of the model. LMU's are the worst. I start with modelling line connectors first to be...

New column in tank calibration tables: vertical height difference between the top of the fluid in the tank and the bottom of the sounding tube (static fluid head) multiplied by tank_fluid_density * acceleration_due_to_gravity in reponse to this qu...

WHEN PERFORMING "BATCH ANALYSIS" ALL LOADCASES and ALL DAMAGE CASES ARE USED. It could be usefull to be able to select which combinations loadcases/damagecases will be calculated. it would be a great time saver ! Further : it could be also appreci...

Missing Connector MOMENT Report The command &connector(TCNAME -FORCE) only reports FX FY FZ while the three moments are missing. The GSPR connector allows definition of moment stiffness, and in the Freq. or time dynamic report the moments ar...

Since its inception, Marker Error has lacked a sign convention and therefore not indicated the direction of the error, i.e. inside or outside a linked surface. It would be helpful for a sign convention to be applied so that the direction of the er...

Annotations are often overlapped or masqued by the solid shape of the model and unreadable.