Since its inception, Marker Error has lacked a sign convention and therefore not indicated the direction of the error, i.e. inside or outside a linked surface. It would be helpful for a sign convention to be applied so that the direction of the er...

Please add support for 3D Connexion SpaceMouse for zoom/pan and rotation in the graphic views. It would make life so much more pleasant with effective use of the second hand. Works great in Microstation and Rhino, other apps support it too.

Multiframe has Primary and secondary serviceability checks. But often there needs to be more than 2 checks that requires multiple runs of the design to check each desired case. Can Multiframe have tertiary or even four checks for serviceability.

It would be very timesaving if Multiframe results could stream to a specified Word template file rather than just it creating its own file. The template would then be able to have company header to match other computation sheets.

Allow for full directional wave spectra to enable forecast or measured directional wave spectra to be analysed. First step towards this could be to increase the limitation on 1D wave spectra -sea and -a_sea from 5 total to a significantly larger n...

There is no visual way to check the correct postion and orientation of these connector type. When building a new model a lot of time is lost to check correctness of the model. LMU's are the worst. I start with modelling line connectors first to b...

To better automate tasks a VBA method that given the two view angles, a zoom level and the data type (bendingx, von mises .ect) will take a screen shot of the plot window and copy that to the clipboard so it can be placed in a report/excel file. T...

WHEN PERFORMING "BATCH ANALYSIS" ALL LOADCASES and ALL DAMAGE CASES ARE USED. It could be usefull to be able to select which combinations loadcases/damagecases will be calculated. it would be a great time saver ! Further : it could be also appreci...

It will be good if MOSES Potvue provide an option under POST JOINT_CAN command to generate joint strength UC for all load cases instead of just maximum value. This option will be helpful to exclude joint strength UC requirement which has load UC &...

User Suggestion: Locate the Section Library for the previous version of the software and carry it over to the new ones. User requests to record Section Library path, so when I trying to open new version with old model, it will not lose all sections.